Functions

Read identification
Displays full ECU identification such as part number, software/hardware version, manufacturer, and more.

Read fault codes
Shows all stored and pending fault codes with full descriptions.
The program supports printing reports or copying to the clipboard.

Clear fault codes
Clears all stored fault codes and diagnostic information.
Some permanent faults will clear after repair.

Auto-Scan (Full vehicle scan/test)
Detects all ECUs installed in the vehicle and reads all diagnostic trouble codes.
With this diagnostic software, you can perform a full system scan.

You can:
• Read & clear fault codes
• Program, activate, and adapt modules
• View measuring blocks & change basic settings
• Reset service intervals
• Perform brake service with electronic parking brake
• Activate or configure cruise control
• Enable cameras
• Adjust values
• Activate tow-bar functions
• Test actuators
• Display data logging graphically
• Replace rear brake pads on vehicles with EPB
• And much more…

Measuring values
Shows live data such as engine RPM, battery voltage, lambda sensor data, coolant temperature, etc.
Values can be shown as graphs, 9 values at once, or a full list.
Data logging to a file is supported for offline analysis.

Actuator test
Allows activation of individual actuators (e.g., fuel pump on, wheel lock/unlock, door lock/unlock, fuel cut-off, etc.)

Languages available:
English, German, French, Japanese, Russian, Spanish, Portuguese, Swedish, Turkish, Dutch, Polish, Italian, Hungarian, Greek, Czech

Supported models:
Citroën – Peugeot – DS – Opel/Vauxhall